Transmission/Reception Trouble - Toshiba e-studio2505f Fax Manual

7 TROUBLESHOOTING AND SPECIFICATIONS
 Transmission/reception trouble
Below is a list of trouble you might encounter during the transmission/reception.
Transmission troubles
Trouble
TRANSMIT is not displayed even if the
[START] button is pressed.
Originals are fed diagonally.
2 originals are fed together.
The original is not being printed on the
paper of the recipient's Fax even
though it has been sent.
Black lines are shown in the image
that was sent.
Originals are not sent even if
operations are carried out normally.
Originals cannot be sent overseas.
118 Troubleshooting
Check Point
 Is the modular cord disconnected?
 Is the LINE type correctly set?
 Can you receive telephone calls?
 Is there any problem at the recipient's Fax? Check this with
the party trying to receive the original.
 Are the document feeder slides adjusted to the width of the
original that you are sending?
 Does the original that you are sending match the conditions of
transmittable original?
 Have you placed more than the maximum number of originals
that can be placed at one time (50 sheets for 50 to 104 g/m
or 9.5mm or less stack height)?
 Does the original that you are sending match the conditions of
the original that is available for sending?
 Have you pushed the originals into the feeder too hard?
Was the original placed correctly facing up?
When placing the original on the original glass, specify the
original size.
Is the scanning area of the Reversing Automatic Document
Feeder clean?
Clean it with a soft cloth.
Is the recipient's Fax compatible with your system?
This system supports G3 communications but not G2 or G4
communications.
Specify Quality TX and resend.
 P.31 "Setting the transmission conditions"
2