Toshiba e-studio2505f Fax Manual page 28

2 SENDING A FAX
 Setting originals on ADF
This section describes how to set originals on the ADF (Automatic Document Feeder). When
the originals are placed on the ADF, the uppermost page is the first to be scanned and sent.
1
After aligning the originals, place them with their face up and slide
the guides to rest against the edges of the originals.
 Regardless of their sizes, originals are acceptable up to 50 sheets (50 to 104 g/m
(13.3 to 27.7 lb.)) or 9.5 mm (0.37") in height.
 When an original of any size other than LT/A4 is placed in the direction shown in
the above left figure, transmission to a recipient is carried out so that the pre-
entered sender information is printed in position A in the figure.
 When an original of LT/A4 size is placed in the direction shown in the above right
figure, transmission to a recipient is carried out so that the pre-entered sender
information is printed in position B in the figure.
 The pre-entered sender information shows what is registered in the Terminal ID.
 P.103 "Registering the Terminal ID"
26 Basic Procedures
A
2
B