Transmission/Reception Trouble - Toshiba GD-1320 Operator's Manual

7.TROUBLESHOOTING AND SPECIFICATIONS
Never attempt to repair, disassemble or modify the equipment by yourself.
You could cause a fire or get an electric shock. Always contact your service representative for maintenance or
repair of the internal parts of the equipment.
For error messages not listed above and their solutions, refer to the Troubleshooting Guide.
 Transmission/reception trouble
Below is a list of trouble you might encounter during the transmission/reception.
Transmission troubles
Trouble
TRANSMIT is not displayed
even if the [START] button is
pressed.
Originals are fed diagonally.
2 originals are fed together.
The original is not being printed
on the paper of the remote Fax
even though it has been sent.
Black lines are shown in the
image that was sent.
Originals are not sent even if
operations are carried out
normally.
Originals cannot be sent
overseas.
 Did you replace the handset before you pressed the [START] button?
When you are making a call on the handset to send a Fax, do not
replace the handset until you press the [START] button.
 Is the modular cord disconnected?
 Is the power plug unplugged from the power outlet?
 Can you receive telephone calls?
 Is there any problem at the remote Fax? Check this with the party
trying to receive the original.
 Are the document feeder slides adjusted to the width of the original
that you are sending?
 Does the original that you are sending match the conditions of the
original that is available for sending?
 Have you placed more than the maximum number of originals that
can be placed at one time?
 Does the original that you are sending match the conditions of the
original that is available for sending?
 Have you pushed the originals into the feeder too hard?
Was the original placed correctly facing up?
When placing the original on the original glass, specify the original size.
Is the scanning area of the Reversing Automatic Document Feeder
clean?
Clean it with a soft cloth.
Is the remote Fax compatible with your system?
This system supports G3 communications but not G2 or G4
communications.
Specify Quality TX and resend.
 P.29 "Setting the transmission conditions"
7 TROUBLESHOOTING AND SPECIFICATIONS
Check Point
Troubleshooting 119