Wired Clone Mode - HYT TC-580 Service Manual

CH n
TX Freq
CH n
Option Items
CH n
RX CTC/CDC
CH n
TX CTC/CDC

Wired Clone Mode

1. Description
Wired Clone mode is an independent mode. To access other modes, you must restart the radio.
Wired Clone mode includes Clone mode and Factory Clone mode.
1) Clone Mode:
Connect two radios using a cloning cable. Then press and hold down SK1 for 2 seconds while
powering the source radio on, and the radio enters Clone mode. The target radio can be directly
turned on to enter the mode. In this mode, data stored in EEPROM of the source radio will be cloned
to EEPROM of the target radio. The data transferred only covers channel data and common
parameters, excluding adjustment data, version and serial No. of the model.
2) Factory Clone Mode:
TX Freq
Displays the TX frequency. Press OK to edit.
350.00000
Option Items
Sets the spacing of the current channel.
CH Space
Option Items
Sets the power level of the current channel.
Power Level
Option Items
Sets the whisper feature on the current channel.
Whisper
Option Items Sets the compandor feature on the current
Compandor channel.
Option Items Sets the scrambler feature on the current
Scrambler channel.
RX CTC/CDC Sets not to receive CTCSS/CDCSS on the
CTC/CDC None current channel.
RX CTC/CDC Displays the RX CTCSS on the current channel.
CTC
Press OK to edit it.
RX CTC/CDC Displays the RX CDCSS on the current channel.
Normal CDC
Press OK to edit it.
RX CTC/CDC Displays the RX CDCSS on the current channel.
Invert CDC
Press OK to edit it.
TX CTC/CDC Sets not to transmit CTCSS/CDCSS on the
CTC/CDC None current channel.
TX CTC/CDC Displays the TX CTCSS on the current channel.
CTC
Press OK to edit it.
TX CTC/CDC Displays the TX CDCSS on the current channel.
Normal CDC
Press OK to edit it.
TX CTC/CDC Displays the TX CDCSS on the current channel.
Invert CDC
Press OK to edit it.
8
TC-580 Service Manual