HYT TC-580 Service Manual page 46

Switch to and enter
CDC Dev. WFP1 at
low frequency is set
by default.
Communication
Short press UP/DN to
Test Set
switch the frequency.
BPF:
Tune WFP5 in CDC
<20Hz~300Hz
Dev, and then press
AF Genl Lvl: off
UP to enter NFP1 at
low frequency.
Short press UP/DN to
switch the frequency.
Switch to and enter
CTC Dev L. WFP1 at
low frequency is set
by default.
Short press UP/DN to
switch the frequency.
Tune WFP5 in CTC
Dev L, and then press
UP to enter NFP1 at
low frequency.
Switch to and enter
CTC Dev M. WFP1 at
low frequency is set
Communication
by default.
Test Set
Short press UP/DN to
BPF:
switch the frequency.
<20Hz~300Hz
Tune WFP5 in CTC
AF Genl Lvl:
Dev M, and then
off
press UP to enter
NFP1 at low
frequency.
Switch to and enter
CTC Dev H. WFP1 at
low frequency is set
by default.
Short press UP/DN to
switch the frequency.
Tune WFP5 in CTC
Dev H, and then press
UP to enter NFP1 at
low frequency.
Press SK1/SK2 to
tune the CDCSS
Press
Antenna deviation, and press
SK1/
Connector OK to save and exit
SK2
upon completion of
all settings.
Press SK1/SK2 to
tune the CTCSS
Press
Antenna deviation, and press
SK1/
Connector
OK to save and exit
SK2
upon completion of
all settings.
45
TC-580 Service Manual
700±50Hz
450±50Hz
Wide band:
700±50Hz
Narrow
band:
450±50Hz