X10 Transmitter Connections - Magellan MG-6060 Programming Manual

X10 Transmitter Connections

1. Connect one end of the inverted
4-pin RJ-11 cable into the X10
plug of the console.
2. Connect the other end of the
inverted 4-pin RJ-11 cable into
the X10 transmitter.
3. Plug the X10 transmitter into a
standard wall outlet.
For information on
programming the X10
features of Magellan, refer to
the X10 Operation User
Guide which can be found
and downloaded for free
from our Web site at
www.paradox.ca.
X10 devices (transmitters,
modules, etc.) are not
supplied and cannot be
purchased through Paradox
Security Systems Ltd.
Magellan
Figure 8: Connecting the X10 Transmitter
1
Inverted
4-pin
RJ-11
cable
Make sure that an inverted 4-pin
RJ-11 cable is used when
connecting the Magellan console to
the X10 transmitter. Note the pin
configuration below:
Magellan X10
Console Transmitter
Pin 1 Pin 4
Pin 2 Pin 3
Pin 3 Pin 2
Pin 4 Pin 1
Back view of the Magellan console.
Do not connect the X10
transmitter into this plug.
Inverted 4-pin
RJ-11 cable
3
X10 transmitter
2
39