Connecting To A Uip-256; X10 Transmitter Connections (Mg-6160 Only) - Magellan MG-6130 Programming Manual

Connecting to a UIP-256

Connect the 10-
pin cable of the
UIP-256 to the 10-
pin connector of
the Magellan
console
UIP-256
Universal
In-Field
Programmer

X10 Transmitter Connections (MG-6160 only)

1. Connect one end of the inverted
4-pin RJ-11 cable into the X10
plug of the console.
2. Connect the other end of the
inverted 4-pin RJ-11 cable into the
X10 transmitter.
3. Plug the X10 transmitter into a
standard wall outlet.
For information on
programming the X10
features of Magellan, refer to
the X10 Operation User
Guide which can be found
and downloaded for free
from our Web site at
paradox.com.
X10 devices (transmitters,
modules, etc.) are not
supplied and cannot be
purchased through Paradox
Security Systems Ltd.
Magellan
Figure 12: Connecting to a UIP-256 Universal In-Field Programmer
Standard
DB-9 cable
(9-pin serial
cable)
Figure 13: Connecting the X10 Transmitter
1
Inverted
4-pin
RJ-11
cable
Back view of the
Magellan console.
Download latest
firmware version of
Magellan from the
Paradox website at
paradox.com
Make sure that an inverted 4-pin
RJ-11 cable is used when
connecting the Magellan console to
the X10 transmitter. Note the pin
configuration below:
Magellan X10
Console Transmitter
Pin 1 Pin 4
Pin 2 Pin 3
Pin 3 Pin 2
Pin 4 Pin 1
Back view of the Magellan console.
Do not connect the X10
transmitter into this plug.
Inverted 4-pin
RJ-11 cable
3
X10 transmitter
2
25