Entering Programming Mode; Single Digit Data Entry Method; Feature Select Programming Method - Magellan MG-6060 Programming Manual

Entering Programming Mode

Use the built-in keypad to access Magellan's installer programming mode. To access programming mode:
1. Press and hold the [0] key.
2. Enter your [
INSTALLER CODE
3. Enter the 3-digit [ ] you wish to program.
SECTION
4. Enter the required [ ].
DATA
5. Press the [*] key to clear data or to go back one step. Press the [#] key to save changes.
There are two methods that can be used to enter data when in programming mode; Single Digit Data Entry and Feature Select Programming methods.

Single Digit Data Entry Method

After entering programming mode, some sections will require that you enter decimal values from 000 to 255. Other sections will require that you
enter hexadecimal values from 0 to F. The required data will be clearly indicated in this manual. When entering the final digit in a section, Magellan
will automatically save and advance to the next section. Refer to Figure 1 on page 6 to see the keys and their equivalent decimal and/or hexadecimal
value.

Feature Select Programming Method

After entering certain sections, eight options will be displayed where each option from [1] to [8] represents a specific feature. Press the key
corresponding to the desired option and the option number will appear in the LCD screen. This means the option is ON. Press the key again to
remove the digit from the LCD screen (a * appears), thereby, turning OFF the option. Press the [*] key to set all eight options to OFF. When the
options are set, press the [#] key to save and advance to the next section.
Magellan
] or [ ].
MAINTENANCE CODE
7