Telephone Line Connections; Programmable Outputs - Magellan MG6250 Section Programming Manual

Telephone Line Connections

The MG6250 console can be connected to a telephone line by connecting the telephone company's wires directly to the dialer of the console.
Direct Connect
Connect the telephone line through a RJ31X jack as shown in figure 11.
Figure 11: Telephone Line Direct Connect
To connect the
telephone line:
1. Connect a RJ31X to
the R-1, T-1, RING
and TIP terminals as
shown above.
2. Connect the telephone
company wires and the home
telephone on the RJ31X.
Programmable Outputs (PGMs)
The MG6250 comes equipped with two 50mA open-collector outputs; Max. handling current 50mA. When a specific event occurs in the system, a PGM can be
programmed to activate lights, garage door openers, etc. See PGM Options on page 10 for more information on programming PGMs.
Connect the MG6250 PGM outputs as shown in Method 1 in figure 12. Since the MG6250 does not come with a power supply, an external power supply must be
employed to power the circuit.
If the current draw on the PGMs is to exceed 50mA, we recommend using an external relay as shown in Method 2 in figure 12. For connecting the PGM2, see figure
13.
NOTE: Using Method 2, connect the device to the output terminal of the external relay that matches the normal state of the MG6250's PGM output. Keep in mind
that the maximum voltage of PGM1 and PGM2 is 12Vdc.
Figure 12: PGM1 and PGM2 Connections
Method 2
(more than 50mA)
RED
BLK
COM
(WHT)
GRN YEL
N.C. N.O.
External relay
50 | Installation
Method 1
(less than 50mA)
Devices such as light, etc.
Network
RJ31X
Service
or
Provider's
RJ38X
Facilities
jack
Telephone line
Network
demarcation point
Telephone
Answering
machine
Computer
Devices such as light, etc.
External DC Power Supply
MG6250 • Section Programming Guide
Magellan
console
Unused
RJ-11 jack
Unused
RJ-11 jack
Telephone
Version 1.6
Telephone