System Settings; Installer Quick Keys - Magellan MG-6060 Programming Manual

System Settings

Section Data
[180] ____/____/____
[181] ____/____/____/____/____/____
[182] ____/____/____/____/____/____
[200] Reset Master code to default (123456)
[201] Reset all programmable sections to factory default values

Installer Quick Keys

To access the Installer Quick keys, press and hold the [0] key from the Main keypad, enter the [installer code] and then press from the Center keypad:
Key [1] = Test Report: Send the "Test Report" report code programmed in section [155] (page 23) to the central monitoring station.
Key [2] = Cancel Communication: Cancels all communication with the WinLoad software or with the central monitoring station until the next reportable
event.
Key [3] = Answer WinLoad Software: Will force the console to answer an incoming call from the central monitoring station that is using the WinLoad
software.
Key [4] = Call WinLoad Software: Will dial the PC telephone number programmed in section [118] (page 20) in order to initiate communication with a
computer using the WinLoad software.
Key [5] = Installer Test Mode: The installer test mode will allow you to perform walk tests where the siren will squawk to indicate opened zones. Press the
[5] key again to exit.
26
Description
Installer code lock
(Enter 147 to lock code, 000 to unlock code)
Installer code
( [4] [8] )
Maintenance code
( [4] [8] )
Defaults
000
000000
111111
Programming Guide