Table of Contents
Advertisement
User Manual
4.11 Logout/Shutdown/Reboot
To do Logout User, Shutdown, Restart operations by " Main Menu" -> " Shutdown" menu as below GUI:
l Logout: Device will auto-lock after logout.
l Shutdown: After you shutdown here, please click the power button in front panel to start up DVR.
4.12 Password Reset
When user forget the DVR host administrator password, please recover password by following steps:
1. Shutdown DVR host. Cut off the power supply.
2. Remove the cover screws to open the case cover.
3. Find the 3 feet pin near the SCM in back of front panel.
4. Use the jumper cap to make the 1, 2 feet in a short circuit state. (The jumper cap default in 2, 3 foot when leave factory).
5. Turn on the power to start the host, the front panel buzzer will beep, indicating that the password has been cleared to the factory defaults.
6. Shutdown the host and cut off power supply again.
7. Unplug the jumper cap and return the jumper cap to default 2, 3 feet.
8. Fixed on the chassis cover, password reset is complete.
4.13 Power Resume
When system is in standby or running state, if system was cut off power supply abnormally, after the power supply recovered, the system will auto-start up and recover to the working
state before power supply cut off. It can make the system work continuous when system may loss power supply.
eLineTechnology.com
72
Advertisement
Table of Contents
