Table of Contents
Advertisement
User Manual
4.7.5 PTZ Setting
Enter into PTZ Setting interface by " Main Menu" -> " System Setup" -> " PTZ Setting" , the interface is as follows:
PTZ Control Setting steps:
l Set the COM type, COM device and baud rate in COM Setting interface.
l Set the PTZ Protocol and address code. (Default PTZ address code correspond to channel number. It means the address code of first channel is 1.)
Note: The PTZ protocol, baud-rate and address code should be the same with Dome Camera Protocol.
l Swith the channel which you want to control PTZ to whole screen. Press the " PTZ" key on the remote controller to get in the PTZ control mode, then you can use the remote controller
to control the PTZ, press " PTZ" again you can quit the PTZ control mode; You can long press " PLAY/PTZ" button in DVR front panel (3 seconds) or right click the mouse to enter
the PTZ control interface.
Note: Drag the interface to move it.
l Setting and calling preset point by the remote controller:
Enter the PTZ status, press the direction button make the PTZ turn the direction which you want to set as preset point, press " *preset" button on remote controller and input the No.
of the preset point in the text field, such as 001, then turn the PTZ to another direction, if you press the " #call" button and input the No. 001 which you preset to the text field, the PTZ
will turn to the 001 preset point automatically.
Note: value range 1-255, 255 means close.
eLineTechnology.com
54
Advertisement
Table of Contents
