E-line ELI-PRO3 series User Manual page 52

User Manual
(4) Video adjustment
l Click " Video adjustment" button in channel setting interface to enter into channel parameter setting interface. Or you can press
" Image" button in remote controller or front panel to enter " Video Adjustment" interface after login DVR as right picture:
l System default channel parameters: Brightness 128, Contrast 128, Saturation 128, Hue 128.
l Channel No.: Used to switch channels, user can also setup all channels directly.
Adjustment Method:
l Select the parameters you want to change, then press " +" , " -" button on the remote controller.
l Click the left mouse on the " +" , " -" to change the value, the " +" , " -" on the interface can indicate the increase or decrease of the value.
(5) Channel name position
Channel name default at top left corner. Click " CH name pos." button to enter into channel name setting interface, drag the channel
name to any position you want in the screen.
2. OSD
Enter into " Output" -> " OSD" , the interface is the right picture. You can set date format, displaying time, displaying channel name, displaying temperature.
3.Sequence
Enter into " Output" -> " Sequence" , the interface as follows. The function is to realize different
channels switching, can set the sequence channels, sequence image format and sequence cycle.
l Sequence Cycle: Sequence interval is 3-60 seconds.
l Division Mode: Have 1 image, 4 images two options.
l Sequence channel no.: It will the same or bigger than the number of division mode.
Note: Function only available when DVR in lock status!
4. SPOT Setting
Enter " Main Menu" -> " Output Setting" -> " SPOT" as below interface, SPOT setting steps:
(1) Enable " Sequence" button. Input the Sequence cycle time (unit is second) and select sequence channel.
Note: The channel participate in sequence can' t be repeat.
(2) There has a special output for SPOT in DVR back-panel. It' s CVBS output.
(3) SPOT will only work when DVR in lock status.
52
eLineTechnology.com