Table of Contents
Advertisement
User Manual
4.8.1 Basic Information
You can check the general information of HDD in HDD management, the interface is as follows:
1) Check the HDD general information: The first row display the disk number corresponding to disk interface; The second row display the HDD device; The 3, 4, 5, 6 rows display
the partition type, status, total capacity, and available capacity. The system only support FAT32 format, please use the HDD which above 32G; If there have multi-partition in one HDD,
the system only read the first partition.
2) Try to use: when disk is abnormal, choose the corresponding disk and click " Try to use" , then the host will forced to use the disk and the host will use the normal partition in it
after rebooting.
3) HDD property: There are Read-Write and Read-only two kinds of attribute, default as Read-Write. If you want to prevent that the important record to be deleted or overwrote and
protect the record, you can set the HDD as Read-Only. Setting steps: Click the " Attribution" button in " Basic information" interface, then open " Disk property setting" interface, set
the " Attribute" value as " Read-Only" , then click " Save" button.
4) HDD Format: Select the right disk number which you want to format, then click the " Format" button.
Notes: When you formating log file, you need select the right HDD which stored the log before click " Format log" button.
eLineTechnology.com
62
Advertisement
Table of Contents
