Adjustment, Periodic Maintenance, Periodic Replacement Parts, And Replacement Consumables By Service Engineer - Canon MX700 Service Manual

MX700
1. MAINTENANCE
1-1. Adjustment, Periodic Maintenance, Periodic Replacement Parts, and Replacement
Consumables by Service Engineer
(1) Adjustment
Adjustment
EEPROM
initialization
Destination settings
(EEPROM
settings)
Ink absorber
counter resetting
(EEPROM
settings)
Ink absorber
counter value
setting
(EEPROM
settings)
Paper feed motor
position adjustment
Carriage rail
position adjustment
Print head
alignment
Grease application - At carriage unit or carriage
Ink system function
check
LCD language
settings
Document pressure
sheet position
adjustment
Timing
- At logic board replacement
- At logic board replacement
- At logic board replacement
- At ink absorber replacement
- At logic board replacement
- At ink absorber replacement
- At paper feed motor
replacement
- At carriage unit replacement
- After carriage rail removal
and re-assembly
- At print head replacement
- At logic board replacement
- When print quality is not
satisfying
rail replacement
- At LF earth spring or paper
feed roller replacement
- At PG - AP arm lever
replacement
- At logic board replacement
- At spur base replacement
- At carriage unit replacement
- At logic board replacement
- At document pressure sheet
replacement
- DF Base replacement
Purpose
To initialize settings
To set destination.
To reset the ink absorber
counter.
To set the ink amount data in the
ink absorber to the ink absorber
counter.
To adjust the belt tension.
(Position the paper feed motor
so that the belt is stretched
tight.)
To adjust the distance between
the print head and paper
(between the carriage and the
platen).
To secure the dot placement
accuracy.
To maintain sliding properties of
the following items:
- Carriage rail
- LF earth spring
- Eject roller
- PG
- AP arm lever
To maintain detection
functionality for presence of the
ink tanks and each ink tank
position.
To set the language to be
displayed on the LCD.
Hold the sheet with the long side
down, then position its upper left
corner approx. 1 mm in from the
platen glass reference edges
(back left).
1 / 41
TABLE OF CONTENTS
Tool
None. 1 min.
Perform in the service
mode.
None. 1 min.
Perform in the service
mode.
None. 1 min.
Perform in the service
mode.
None. 1 min.
Perform in the service
mode.
None. 5 min.
None. 5 min.
None. 3 min.
(Manual)
- FLOIL KG-107A 1 min.
- IF-20
- MOLYKOTE PG641
None. 1 min.
Perform in the service
mode.
None. 1 min.
Perform in the user
mode.
None. 1 min.
Approx.
time