Other Error Messages - Canon MX700 Service Manual

2-4. Other Error Messages

Message on the LCD
The selected paper cannot be fed from
front tray. Change the paper source and
press [OK].
Borderless print is not available for
paper from front tray. Change the paper
source and press [OK].
Change the setting(s).
Device memory is full. Reduce the
number of documents (photos, etc.)
to scan or copy.
Failed to scan. Either document cannot
be scanned or is not placed on the platen
glass.
Press <>.
(<>: Color button icon)
Press <>.
(<>: Black button icon)
There are no photos in memory card.
The value exceeds the number of copies
you can print.
Memory card is not set. Insert the card
after checking the direction.
DPOF information is not saved in the
memory card.
The number of copies to print is not set.
Input the number of copies.
This layout is available only for A4 or
8.5"x11"(215x279).
Change the setting after removing the
card.
The card is currently write-enabled. Set
to read-only mode before performing
operation.
The paper size is not correct. Check the
page size you have set.
Cause
The paper type being used is not supported for
paper feeding from the front tray.
Borderless print is attempted when the front
tray is selected as the paper source.
Settings made conflict each other. (e.g.
Selecting borderless printing on plain paper)
The memory is not sufficient to do the print job
in copying.
The machine failed in scanning the document
for Fit-to-page copy, or photos or films were
not recognized in pre-scanning.
The Black button was pressed, but it is invalid. A temporary error. Press the Color button to
The Color button was pressed, but it is invalid. A temporary error. Press the Black button to
Supported image files are not in the memory
card.
During selecting images or specifying the
number of copies, the total print quantity
exceeds the prescribed value of 999.
The memory card is not inserted in the slot
properly.
DPOF print was selected in the menu, but no
DPOF files are contained in the memory card.
Printing was attempted without specifying the
print quantity (with the print quantity left
"0" (zero)).
In Layout print, "Mixed 1, 2, or 3" which is
available only with A4 or Letter size paper is
selected, but the paper size is not set to A4 or
Letter.
With a memory card inserted in the slot,
change of the Read/Write attribute was
attempted.
With the memory card set to the Read/write
mode, Card Direct printing operation was
attempted from the menu.
Non-supported size of paper for Camera Direct
printing via PictBridge connection is selected.
10 / 41
Solution
Change the paper source to the rear tray.
Change the paper source to the rear tray.
Change the settings so that they will not
conflict each other.
Reduce the amount of data to be printed, or
print from a computer.
Press the OK button to clear the error.
continue the operation.
continue the operation.
A temporary error.
- Confirm that supported image files are in the
memory card.
- Images with double-byte characters used in
the file name (or folder name) may not be
recognized. Change the file (or folder) name
so that it contains only single-byte
alphanumeric characters.
- If images are edited on the computer, print
them from the computer.
A temporary error. The last operation before
the error is cancelled, and the total print
quantity returns to the value before the error.
Set a memory card.
A temporary error. The LCD automatically
returns to the display before the error
occurrence.
A temporary error. Specify the print quantity.
A temporary error. The LCD automatically
returns to the display before the error
occurrence.
A temporary error. Remove the memory card,
then change the Read/Write attribute.
A temporary error. Remove the memory card,
change the memory card setting to Read-only,
then perform Card Direct printing.
Cancel printing on the digital camera. Confirm
the paper size, and print again.