Lexmark Infoprint 1332 User Manual page 67

User attendance messages (continued)
Primary message
235 Duplex Paper Jam -
Front
236 Duplex Paper Jam -
Front
237 Duplex Paper Jam -
Front
238 Duplex Paper Jam
239 Duplex Paper Jam
24x Paper Jam
Check Tray x
250 Paper Jam
Check MP Feeder
260 Paper Jam
Check Envelope Feeder
27x Paper Jam
Check Output
Secondary message
Leave Job in Finisher
Leave Job in Finisher
Leave Job in Finisher
Leave Job in Finisher
Leave Job in Finisher
Explanation
Primary: A piece of media is over the duplex double
feed sensor.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
Primary: A piece of media did not leave the duplex exit
sensor.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
Primary: A piece of media did not reach the printer
input sensor.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
Primary: A piece of media is over one of the duplex
sensors during a reset.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
Primary: A paper jam has occurred in the duplex
option.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
Paper is jammed around Tray x.
(x=tray 1 thru 5)
Try opening Tray x. If the tray is difficult to remove, then
you may have to remove the tray above or below tray x
to remove the jammed pages.
Paper is jammed in the multipurpose feeder.
Paper is jammed in the envelope feeder.
Paper is jammed in output bin. Open the rear door to
access the jammed pages.
Diagnostic information
Infoprint 1332/1352/1372
2-31