Table of Contents
Advertisement
User attendance messages (continued)
Primary message
59 Incompatible Tray x
59 Incompatible Duplex
61 Defective Disk
62 Disk Full
63 Unformatted Disk
64 Unsupported Disk
Format
80 Scheduled
Maintenance
81 Engine Code CRC
Failure
88 Toner Low
Secondary message
Explanation
An incompatible tray is installed. For Tray x, x= 2, 3, 4,
or 5.
Remove the incompatible tray and press Go to clear
the message.
Note: If the user installed the incompatible device to
satisfy a Check Device Connections/reattach
message, the user should reinstall an associated
compatible option or hot unplug the option.
An incompatible duplex option is installed.
Remove the incompatible duplex option and press Go
to clear the message.
Note: If the user installed the incompatible device to
satisfy a Check Device Connections/reattach
message, the user should reinstall an associated
compatible option or hot unplug the option.
This error code displays when the printer detects a
defective disk. This error may occur at power on or
during disk format and write operations. While this
message displays, press Go to clear the message.
The disk is marked defective and normal printer
operations continue. Disk operations are not allowed
with a defective disk. The Format Disk menu is not
shown.
This error code displays when there is not enough free
space on the disk to hold the resources that have been
requested to be written to the disk. This message
displays for both resource and PostScript Disk
operators when the disk is full.
This error code displays when the printer detects an
unformatted disk at power on. Press Go to clear the
message. The disk is marked as bad and normal
operation continues. Disk operations are not allowed
until the disk is formatted.
The printer detects an unsupported disk format at
POR.
Press Go to clear the message. The disk is marked as
bad and normal operation continues. Further disk
operations are not allowed until the disk is formatted.
The operator panel displays this message at each
300K page count interval. It is necessary to replace
the fuser assembly, transfer roller, charge roll, and pick
rolls at this interval to maintain the print quality and
reliability of the printer. The parts are available as a
maintenance kit. For more information, go to
"Scheduled maintenance" on page
This error displays when the microcode to be
programmed in the engine flash code module has
failed a CRC check. Press Go to clear the message.
The microcode data is discarded and must be re-
transmitted from the host computer.
This message displays when toner low occurs and the
toner low alarm is activated. Press Go to clear this
message.
Diagnostic information
Infoprint 1332/1352/1372
6-1.
2-29
Advertisement
Table of Contents
