HYT TC-700 Ex PLUS User Manual page 14

Please follow these steps:
1. Plug the power cord into the adapter.
2. Plug the AC connector of the adapter into the AC outlet socket.
3. Plug the DC connector of the adapter into the DC socket on the back of the charger.
4. Place the radio with the battery attached, or the battery alone, in the charger.
5. Make sure the battery is in well contact with the charging terminals. The charging process
initiates when the red LED lights.
6. The greed LED lights about 3 hours later indicating the battery is fully charged. Then remove
the radio with the battery attached or the battery alone from the charger.
Note:
It is normal that the charger LED flashes before inserting battery into the charger.
Do not change the battery in the charger until the charger LED is stabilized.
After the battery is placed properly, the LED solidly glows red indicating the battery is
charging, or flashes indicating that the battery is damaged or the ambient temperature is
over high/low.
13