Table of Contents
Advertisement
Target radio
Power On
Low Battery Alert
Transmitting
Receiving
Scanning
Programming
Encoding
(DTMF/PTT ID/2-Tone /HDC1200/HDC2400
Decoding (2-Tone/HDC1200/HDC2400
Select Power Level
Function Key Press
TM
)
TM
)
1)
The LED solidly glows green
during cloning;
2)
The LED flashes green and
the radio sounds the beep
tone, when cloning is
finished;
3)
The LED flashes red when
cloning fails.
The LED flashes green once.
The LED flashes red, and the
radio sounds three beeps every
30 seconds.
The LED glows red
The LED glows green when
carrier presents.
The LED flashes green once
every 1 second.
Reading: the LED glows red;
Writing: the LED glows green.
1)
The LED glows red while
transmitting;
2)
The LED glows orange when
transmission is over.
The LED flashes orange after the
signalling
is
decoded.
1W: One beep is heard;
2W: Two beeps are heard;
4W/5W: Three beeps are heard.
One beep to enable, two beeps to
disable.
successfully
10
Advertisement
Table of Contents
