CipherLab 1660 User Manual page 42

1660 Barcode Scanner
Send Data
For 1660, the 256 KB flash memory can store up to 16,384 scans based on EAN-13 barcodes. For
1661, the 512 KB flash memory can store up to 32,768 scans based on EAN-13 barcodes. When it
is used up, the scanner will respond with two short beeps (high-low tone) as a warning. You are
advised to send data to the host immediately by having the scanner read the "Send Data" barcode
below.
For 1660, it will resume the previous WPAN connection with host temporarily.
For 1661, it can send data via "Direct USB" interface when the cable is connected. Otherwise, it
will resume the previous WPAN connection with host temporarily. Refer to
Direct USB Cable.
Clear Data & Confirm
Even though data has been sent back to the host, the flash memory is still occupied unless you
erase the memory by having the scanner read two barcodes – "Clear Data" and "Confirm".
1. Read the "Clear Data" barcode to clear the flash memory.
2. Read the "Confirm" barcode to confirm the action.
28
User Guide
5 sec
8 sec
Send Data
Clear Data
Confirm
Enter Setup
1.13 1661 Using