CipherLab 1660 User Manual page 30

1660 Barcode Scanner
The example below shows how to set string parameters:
Steps Action
1 Power on the scanner...
2 Enter the Configuration Mode...
3 Read a Setup barcode...
For example,
Special setup
barcodes
Hexadecimal
barcodes
4 Exit the Configuration Mode...
5 The scanner will automatically restart itself...
16
User Guide
OR
User Feedback if Successful
The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off quickly.
The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
The scanner will respond with one short
beep if reading a special setup barcode
such as "Prefix Code", indicating the setup
requires reading more barcodes.
When "BT HID" or "USB HID" is configured
for interface, Key Type and Key Status will
then become applicable. You may decide
whether or not to change key status when
"Normal Key" is selected for Key Type.
Refer to Appendix III
Read the "Hexadecimal Value" barcodes
for the desired character
example, read "2" and "B" for the scanner
to prefix the character "+".
Refer to Appendix IV "Hexadecimal
System"
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
Same as for Enter the Configuration Mode.
Same as for Power on the scanner.
Enter Setup
string. For