CipherLab 1660 User Manual page 39

1) Read the barcode above to specify the time interval before the scanner automatically
turns off.
2) Read the "Decimal
scanner to automatically turn off after being idle for 15 minutes.
3) Read the "Validate" barcode on the same page to complete this setting.
Note: Auto Power Off will not take effect when the scanner is in the configuration mode.
1) Read the barcode above to specify the time interval before the scanner enters
low-speed mode.
2) Read the "Decimal
scanner to enter low-speed mode after being idle for 5 minutes.
3) Read the "Validate" barcode on the same page to complete this setting.
Note: Power-Saving will not take effect when one of the following conditions is met:
(1) the scanner has already established a BT HID/SPP connection,
(2) the scanner is in the configuration mode,
(3) the scan mode is set to Test, Continuous or Alternate Mode, or
(4) the setting value of Power-Saving is greater than that of Auto Power Off.
Value" barcode on page 217. For example, read "1" and "5" for the
Value" barcode on page 217. For example, read "5" for the
Chapter 1 Understanding the Barcode Scanner
Auto Off after
0~254 min. (*10)
Power-Saving after
0~254 min. (*2)
Update
25