Management Module Controls And Indicators - IBM eServer BladeCenter T8720 Installation And User Manual

Management module controls and indicators

These management-module controls and indicators provide status information about
the management module and remote management connection. For additional
information, see the Hardware Maintenance Manual and Troubleshooting Guide on
the IBM BladeCenter T Documentation CD.
Management module LEDs: These LEDs provide status information about the
management module and remote management connection.
v Power: When this green LED is lit, it indicates that the management module has
v Active: When this green LED is lit, it indicates that the management module is
v Error: When this amber LED is lit, it indicates that an error has been detected
Management module IP reset button: Do not press this button unless you intend
to erase your configured IP addresses for the management module and lose
connection with the remote management station, the switch modules, and the blade
servers. If you press this button, you will have to reconfigure the management
module settings (see the information beginning with "Setting up the remote
connection" on page 63 for instructions).
Press this recessed button to reset the IP configuration of the management module
network interfaces (Ethernet 1, Ethernet 2, gateway address, and so on) to the
factory defaults and then restart the management module.
Use a straightened paper clip to press the button.
52
BladeCenter T Types 8720 and 8730: Installation and User's Guide
power.
actively controlling the BladeCenter T unit. Only one management module
actively controls the BladeCenter T unit. If two management modules are
installed in the BladeCenter T unit, this LED is lit on only one.
somewhere on the management module. When this LED is lit, the system error
LED (critical, major, or minor) on each of the BladeCenter T system-status panels
is also lit.
Management Module
Power
IP reset button
Active
Error