Advertisement
Setup for Printing
Loading Flat Material
1
Pass the material between the pinch rollers and the grit
rollers as shown in the figure.
3
Move the sheet loading lever toward LOAD.
The pinch rollers lower to hold the material in place.
Sheet loading lever
5
Press the [SETUP] key. This detects the width and
length of the material and shows the printable width
and length on the display.
The SETUP LED lights up
*If the material is misaligned and looks like it might
come loose from the pinch rollers, or actually does
come loose, please reload the material.
Refer to your CAMMJET/Hi-Fi JET user's manual for detailed instructions on working with the unit.
Top menu
W1000mm L1230mm
FINE
BI-DIR
2
Refer to steps 5 and 6 in "Loading Roll Material," and
position the material and the pinch rollers correctly.
4
Close the front cover.
Use the [
] and [
press the [ENTER] key.
SETUP SHEET
ROLL EDGE PIECE
Note for CAMMJET: If a pinch roller is positioned over an
area where there is no grit roller, the message shown at below
appears when you press the [SETUP] key.
PINCHROLL ERROR
INVALID LEFTPOS
Check the positioning of the pinch rollers and
make sure they are aligned at the correct positions.
2
] keys to select [Piece], then
or [RIGHT]
Advertisement
