KTM 450 SX ATV 2010 Repair Manual page 82

10/REAR WHEEL
–
Position O-ring
–
Carefully insert sealing area
the rear wheel eccentric by lightly turning and tilting the rear axle.
Info
Do not damage the sealing lip of the shaft seal ring.
600425-10
–
Lightly grease the thread of the clamping nut.
Long-life grease (
–
Ensure that the rear axle and the brake disc holder have been correctly installed.
–
Turn clamping nut
Info
LH thread!
600426-10
–
Position lock rings
600427-10
–
Tighten the clamping nut in the direction of the arrow using the special tool.
Guideline
Clamping nut, rear axle
600428-10
Open-end wrench attachment, 46 mm (83019010461) (
–
Tighten screw
Guideline
Screw, clamping nut, rear axle
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, rear brake caliper
–
Clean the brake disc and brake disc holder.
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a pressure point.
–
Fill the rear wheel eccentric with grease via grease nipple
600429-10
Long-life grease (
. Attach brake disc holder

on the brake disc carrier into the shaft seal ring of

p. 224)
all the way onto the brake disc holder.

.

2"-10UNS-
2B-LH
.

M6
M6
p. 224)
with the thread facing outward.

25 Nm Only applies when
(18.4 lbf ft) using:
Open-end wrench
attachment,
46 mm
(83019010461)
( p. 234)
p. 234)
10 Nm (7.4 lbf ft)
.

10 Nm Loctite ® 243™
(7.4 lbf ft)
.

80