Table of Contents
Advertisement
61/ATV FRONT END
3
1
–
Remove flange adapters
–
Remove shaft seal rings
–
Remove spacing washers
Info
The spacing washers are only installed at the front pivot point.
3
5
5
1
4
2
4
and bearing sleeves
.
.
.
–
Press out needle bearing
Press mandrel (83019020170) (
Press mandrel (83019020130) (
–
Clean the pivot point.
600458-01
–
Press in a new needle bearing on all pivot points using the thick end of the special
tool.
Press mandrel (83019020170) (
–
Grease the needle bearing.
–
On the front pivot point, insert the two spacing washers.
600459-01
–
Install the new shaft seal rings. Lightly grease the sealing lips of the shaft seal
rings.
–
Mount the bearing sleeves and flange adapters.
using the thin long side of the special tool.
Info
The needle bearing cannot be pushed through from one side.
5
5
1
3
2
3
A
6
7
p. 236)
p. 236)
p. 236)
202
1
600457-01
Advertisement
Table of Contents
