System Setup - Pro Tools Hd Audio Interface Mode; Toolbar - Apogee Symphony I/O User Manual

the sample rate of the external source is displayed and the drop down is greyed
out.
3. Peak Hold - This pop-up menu sets the time that peak indications are held on
software and front panel meters.
4. Over Hold - This pop-up menu sets the time that over indications are held on
software and front panel meters.
5. See Working with Front Panel and Software Level Meters for more details.

System Setup - Pro Tools HD Audio Interface Mode

When Audio Interface Mode is set to Pro Tools HD, most settings are made in Pro Tools.
1. Clock Source - To set clock source, choose Setup > Hardware in Pro Tools and set
the Clock Source drop down.
2. Sample Rate - The sample rate of a Pro Tools system is always set by the Pro Tools
session, and may not be changed once set during session creation.
3. Peak Hold - This pop-up menu sets the time that peak indications are held on
software and front panel meters.
4. Over Hold - This pop-up menu sets the time that over indications are held on
software and front panel meters.
See Working with Front Panel and Software Level Meters for more details.

Toolbar

The toolbar is reserved for system controls that must remain easily accessible.
1. Clear Meters - this button clears all held peak and over indications on all hardware
and software meters.
2. System Status - this window displays the clock source, sample rate and system
status of the currently selected system. A system status of "Ready" indicates that all
detected units are properly connected and clocked. Please consult Troubleshooting
or other system status messages.