Setting The Audio Interface Mode - Apogee Symphony I/O User Manual

Setting the Audio Interface Mode

To set the Audio Interface Mode, press and hold the front panel right-hand encoder.
The currently selected Audio Interface Mode is shown on the OLED in solidly
illuminated text. Select the desired Audio Interface Mode by turning the right-hand
encoder - inactive Audio Interface Modes are shown in flashing text. Once the desired
Audio Interface Mode is shown, press the right-hand encoder to confirm the selection.
Symphony I/O will re-boot in the new Audio Interface Mode.
The currently selected Audio Interface Mode is also indicated in Maestro's Device
Settings tab. When connecting multiple Symphony I/Os to Symphony or Pro Tools PCI
cards, be sure set the Audio Interface Mode on each unit first.
Parameter Storage between Audio Interface Modes
When switching between Audio Interface Modes, all settings are saved independently
for each mode. For example, it's possible to configure different routing for Symphony
and Standalone audio interface modes and freely switch between them using the front
panel control described above. Note that calibration settings for are saved
independently for each audio interface mode.