Scanning Sequence Examples; Errors While Scanning - Motorola Symbol LS9208 Product Reference Manual

Symbol LS9208 Product Reference Guide
If you are not using a Synapse or USB cable you must select a host type (see each host
chapter for specific host information). After you hear the power-up beeps, select a host
type. This only needs to be done once, upon the first power-up when connected to a new
host.
To return all features to their default values, all you need to do is scan the Set All Defaults
bar code on page 4-5. Throughout the programming bar code menus, default values are
*
indicated with asterisks ( ).
*
*
High Frequency
Feature/Option
Indicates Default

Scanning Sequence Examples

In most cases you need only scan one bar code to set a specific parameter value. For
example, if you want to set the beeper tone to high, simply scan the High Frequency
(beeper tone) bar code listed under Beeper Tone on page 4-6. The scanner issues a short
high beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as specifying Serial Response Time-Out or setting Data
Transmission Formats, require that you scan several bar codes. Refer to Host Serial
Response Time-out on page 6-21 and Scan Data Options on page 12-9 for descriptions of
this procedure.

Errors While Scanning

Unless otherwise specified, if you make an error during a scanning sequence, just re-scan
the correct parameter.
4-2