Setting Up the Scanner
Installing the Interface Cable
1. Connect the interface cable to the host computer.
2. Plug the interface cable modular connector into the interface cable port on the rear
of the Symbol LS9208 (See
3. Push the connector into the housing until a "click" sound is heard. The green LED
lights up and three short high beeps sound, indicating that the scanner is
operational.
Cable interface
port
Note: Different cables are required for different hosts. The connectors
illustrated in each host chapter are examples only. Your connectors
may be different than those illustrated, but the steps to connect your
scanner remain the same.
Figure
Figure 1-2. Installing the Interface Cable
1-2.)
To host
Getting Started
Interface cable
modular connector
1-3