Symbol LS9208 Product Reference Guide
Connecting to an IBM 468X/469X Host
This connection is made directly from the scanner to the host interface.
1. Connect the interface cable to the rear of the scanner, as described in
Interface Cable
2. Connect the other end of the interface cable to the appropriate port on the host
(typically, Port 9).
3. Scan the appropriate bar codes in this chapter to configure the scanner.
Note: The only required configuration is the port number. Most other
scanner parameters are typically controlled by the IBM system.
8-2
Figure 8-1. IBM Direct Connection
on page 1-3.
Host Port Connector
Interface cable
Installing the