Maintenance - Wacker Neuson BTS 1030L3 Operator's Manual

4.12.6 Store the cut-off saw securely in a dry area. Do not store it outdoors.
4.12.7 Before a long storage period and before shipping the cut-off saw
4.12.8 Proceed especially carefully when storing the cutting blades:
4.12.9 Clean them and dry them well.
4.12.10 Always lay them flat to store them.
4.12.11 Avoid the risk of splintering or breakage by preventing contact with
4.12.12 Check the expiration date before using the synthetic resin cutting
4.12.13 Always check new cutting blades or those from storage for damage

4.13 Maintenance

4.13.1 Before you carry out any maintenance work, always turn off the
4.13.2 Check that the cut-off saw is in a safe operating condition before you
4.13.3 While operating the machine, try to produce as little noise and exhaust
4.13.4 Clean the cut-off saw regularly.
SV00080en.fm
Always detach the cutting blade. Do not allow children near the cut-off
saw.
make sure to follow the "Periodic maintenance and service in-
structions". Always empty the fuel tank and run the carburetor
empty.
NOTICE:
Do not clean synthetic resin cutting blades with water or other liquids!
moisture, frost, direct sunlight, high temperatures or temperature fluc-
tuation!
blades again after storage (engraved on the supporting ring - quarter/
year). If the expiration date has passed, the cutting blade may not be
used.
and test them by running them at least 60 seconds at the specified
maximum speed. Ensure that no one is in the extended swing of the
cutting blade.
27
cut-off saw (27) and pull off the spark plug connector!
start work. Make sure that the cutting blade has been attached accord-
ing to instructions. Also make sure that the cutting blade is undamaged
and suited for the application at hand.
fumes as possible. Check the carburetor setting.
33
Safety information