Attaching The Cutting Blade - Wacker Neuson BTS 1030L3 Operator's Manual

Starting up
7.1

Attaching the cutting blade

T01126en.fm
Set the cut-off saw onto a sturdy base and carry out the following as-
sembly steps:
32
Check the cutting blade for damage. See SAFETY IN-
FORMATION. Unscrew the screw (9) and remove the
clamping disc (8). Set the cutting blade (5) onto the shaft (7).
NOTE: The arbor diameter of the cutting blade must precisely fit the
shaft. If the arbor diameter is larger, you must use an adapter ring (*).
NOTICE:
If you are using diamond-edged cutting blades, make sure
you observe the attached rotational direction mark!
33
Set the clamping disc (8) onto the shaft, screw in together with the
screw (32/9) and tighten by hand.
Turn the cutting blade slowly until you can see the locking bore of the
V-belt pulley bolt through the gear arm hole (10).
Press the offset screwdriver (2) all the way in. The shaft is now
blocked.
Firmly tighten the screw with the combination wrench (1).
NOTE: Firmly tighten the screw to 30 + 2 Nm (22 + 1.5 ft.lbs.), other-
wise the cutting blade may slip while cutting.
42