Maintenance - Wacker Neuson BTS Series Operator's Manual

Safety precautions

4.12 Maintenance

4.12.1 Switch off the cut-off saw (27) and pull out the plug cap Before
4.12.2 Always check the cut-off saw before using it to make sure that it is in
4.12.3 Operate the cut-off saw only at a low noise and emission level. For this
4.12.4 Clean the cut-off saw regularly.
4.12.5 Check the fuel tank cap regularly for good sealing.
SV00068GB
27
performing maintenance work.
good working order. In particular, make sure that the cutting blade is
properly mounted. Make sure that the cutting blade is undamaged and
suitable for the job it will be used for.
ensure the carburetor is adjusted correctly.
Ovserve the accident prevention instructions issued by trade
associations and insurance companies. NEVER make any
modifications to the cut-off saw! You will only be putting your
own safety at risk!
28
Perform only the maintenance and repair works described in the
operator's manual. All other work must be carried out by WACKER
Service.
Use only original WACKER spares and accessories.
The use of non-WACKER spares, accessories, or cutting blades
increases the risk of accident. We cannot accept any responsibility for
accidents or damage occurring in association with the use of
accesories other than original WACKER.
SERVICE
30