Operating Fluids / Filling The Tank - Wacker Neuson BTS 1030L3 Operator's Manual

Safety information
4.4

Operating fluids / Filling the tank

4.4.1
4.4.2
4.4.3
4.4.4
4.4.5
4.4.6
4.4.7
4.4.8
4.4.9
4.4.10 To start the cut-off saw, go to another location (at least 3 meters
4.4.11 Fuels cannot be stored indefinitely. Purchase only enough fuel as you
4.4.12 Only use fuel and oil which has been approved by Wacker Neuson,
SV00080en.fm
Before you fill the tank, go to a a safe and level area. It is prohibited
to fill the tank on a scaffolding, a mound of material or similar el-
evated structure!
Turn off the engine before you fill the tank of the cut-off saw.
6
Smoking and open fires are not permitted (6).
Let the engine cool down before you fill the tank.
Fuels can contain solvent-like substances. Avoid skin and eye contact
with mineral products. When filling the tank, wear gloves (not work
gloves). Change and wash your clothing more often. Do not inhale fuel
vapors. Inhaling fuel vapors can damage your health.
Do not spill fuel. If you have spilled fuel, clean the cut-off saw immedi-
ately. Avoid getting fuel on your clothing. Should you spill fuel on your
clothing, change your clothes immediately.
Make every effort to ensure that you do not allow fuel to soak into the
ground (environmental protection). Use a suitable base.
Do not fill the tank in closed rooms. Fuel vapors accumulate near the
floor (danger of explosion).
Tightly close the screw plug on the fuel tank.
3 meters
(10 feet)
7
(10 feet) away from the place where you filled the tank) (7), however
not in the extended swing area (direction of flying sparks) of the cutting
blade.
can possibly use in the foreseeable future.
see chapter Technical Data.
20