Periodic Maintenance And Service Instructions - Wacker Neuson BTS 1030L3 Operator's Manual

8.13 Periodic maintenance and service instructions

T01127en.fm
The maintenance work described below must be regularly carried out
in to ensure a long service life, prevent damage and ensure that the
safety devices function properly. Warranty claims will only be autho-
rized if this work is carried out properly when scheduled. Non-compli-
ance can cause accidents!
Users of cut-off saws are only permitted to carry out the maintenance
and care procedures described in this operator's manual. All other pro-
cedures may only be carried out by a Wacker Neuson service station.
General Entire cut-off saw
Cutting blade,
clutch
Protective hood
Each time Cutting blade
before
startup
V-belt
Multifunction
switch, safety
switch, throttle
lever
Fuel tank cap
Daily Prefilter
Idle speed
Weekly Starter housing
Starter rope
V-belt
Air cleaner car-
tridge
Spark plug
Muffler
Clean the outside and check for damage. If
damage is discovered, have it repair by quali-
fied personnel immediately.
Check on a regular basis for signs of damage
and wear.
Clean, check position.
Check for damage and whether the correct
cutting blade is mounted for the application at
hand.
Check the V-belt tension.
Functional check.
Check for leakage.
Clean (replace after every 25 hours of opera-
tion and more often if necessary).
Check (cutting blade must not rotate).
Clean to ensure a proper flow of cooling air.
Check for damage.
Check for signs of damage and wear.
Clean (replace after every 100 hours of opera-
tion).
Check and replace as needed.
Check tightness of mounting, clean or replace
spark arrester screen if necessary
69
Maintenance work