Routing cables to external devices
1.
Prepare the computer for disassembly
2.
Remove the rear I/O panel
3.
Remove the power supply cover
4.
Route the cables underneath the rear of the base, then through the hole in the center of the
base, then up through the cable retainer on the neck of the stand and into the appropriate I/O
port.
CAUTION:
connector on the rear I/O so that the cord does not get pulled out of the connector.
(Rear I/O panel on page
(Power supply cover on page
Be sure that the power cord is secured by the retainer clip next to the DC In power
(Preparation for disassembly on page
22).
Routing cables to external devices
19).
20).
25