Installing And Connecting The Unit; Installing The Unit - DVTEL Ioimage trk-101 Installation Manual

3. Installing and Connecting the Unit

This section describes how to install and connect the unit and includes the following sections:


Installing the Unit


Connecting the Unit

Resetting the Unit
Note:
After connecting the unit, proceed to configure the unit as described in the HTML
Edition Units User's Guide.
3.1 Installing the Unit
The unit can be installed and mounted next to the camera (inside the camera enclosure).
Alternatively, the unit can be installed inside an equipment room on a shelf or in a rack using the rack
mount panel that is available as an optional accessory.
When installing the unit make sure that:

It is securely tied down and cannot be easily dislodged

Operating temperatures, at all times, are kept between the minimum/maximum allowed

Proper ventilation is provided so that the air is free to circulate around the unit

The unit is protected from direct weather conditions (for example, sunlight, rain, dust, and so on)
Caution:
To avoid damage from overheating or unit failure, assure that there is sufficient
temperature regulation to support the unit's cooling/heating requirements. Ambient
operating temperature should be kept in the range 0° to 50°C (32° to 122°F), with no
more than 95% non-condensing humidity.
(page 5)
(page 6)
(page 13)
Installing and Connecting the Unit
5