Cleaning And Painting The Stove; Chimney And Chimney Connector Maintenance; Why Chimney Cleaning Is Necessary - Enerzone Destination 1.6 Installation And Operation Manual

Hide thumbs Also See for Destination 1.6:

Table of Contents

Apply self-adhesive gasket (C) en following the engraving on the inside of the door frame.

Reinstall the glass, being careful to centre the glass carefully in the door. Do not over-tighten the

screws. Note that the two main causes of broken door glass are uneven placement in the door and

over-tightening of retaining screws.

Do not abuse the glass door by striking or slamming shut. Do not use the stove if the glass

is broken. To change the glass, perform the same operation described above.

5.1.5 Cleaning and Painting the Stove

Do not attempt to clean or paint the stove when the unit is hot. Painted surfaces can be wiped

down with a damp cloth. Plated surfaces may be scratched by abrasive cleaners. To maintain the

finish at its original brilliance, use only a damp soft cloth to clean plated surfaces.

If the paint becomes scratched or damaged, you can give your wood stove a brand new look by

repainting it with heat-resistant paint. Before painting, roughen the surface with fine sand paper,

wipe it down to remove dust, and apply two thin coats of paint. For best results, use the same paint

that was originally used on the stove, which is available in spray cans. See your dealer for details.

Wood smoke can condense inside the chimney connector and chimney, forming a combustible

deposit called creosote. If creosote is allowed to build up in the venting system it can ignite when a

hot fire is burned in the stove and a very hot fire can progress to the top of the chimney. Severe

chimney fires can damage even the best chimneys. Smouldering, smoky fires can quickly cause a

Destination 1.6 Installation and Operation Manual

Table of Contents

Destination 2.3