Table of Contents
Advertisement
Connections
Connecting the Antennas
Connecting the AM antenna
1
Set up the AM loop antenna
(supplied).
2
Connect the antenna cord.
Main unit (rear view)
Connect the ends of the
antenna cord as shown
above.
3
Turn the AM loop antenna to find the
best position for radio reception.
• Place the AM loop antenna as far from the
main unit as possible.
• Do not place the AM loop antenna on a
metallic table or close to TV, personal
computer, etc. It may result in bad radio
reception.
■ When radio reception with the AM loop
antenna is poor
Twist electric wire and
the AM loop antenna
cord together.
Electric wire
AM loop antenna cord
Electric wire: 3 - 5 m (not supplied
Main unit (rear view)
Stretch out the electric
wire horizontally.
Do not connect the AC power cord until all other connections have been made.
Insert the tab into
the slot.
Main unit (side view)
When insulation
covers the tips of
the antenna cord,
twist and pull off
the insulation.
Main unit (side view)
Keep the AM loop
antenna connected.
Connecting the FM antenna
Main unit
(rear view)
Stretch out the FM
antenna to the best
position for radio
reception, then fix it
with adhesive tape.
■ When radio reception is poor with the
supplied FM antenna, or when using a
communal antenna
Main unit (rear view)
Main unit (side view)
Antenna cord (not supplied)
or
Converter (not supplied:
compatible with 300 Ω/75 Ω)
Depending on the radio reception conditions, an
FM feeder antenna (not supplied: compatible with
300 Ω) can be used. In this case, a converter (not
supplied) is required.
For details of connecting a separately sold
antenna, refer to the instruction manual for the
antenna or converter.
When positioning the antennas, find the best
position for reception while listening to an actual
radio program (refer to "Listening to the Radio"
(
page 13)).
Introduction
FM antenna
(supplied)
Main unit
(side view)
Communal
antenna terminal
Outdoor FM antenna
(not supplied)
Coaxial cable
(not supplied)
5
Advertisement
Table of Contents
