Warning Message; Troubleshooting - JVC GVT0182-005A Instructions Manual

Jvc micro component system instruction manual
Table of Contents

Advertisement

Warning Message

Message
CD NO DISC
Disc is not loaded.
Disc is placed upside down.
Unplayable disc is loaded.

Troubleshooting

Check the following points before contacting the JVC service center.
Problem
No sound is produced from the
speakers.
The clock display is flashing.
Disc playback does not start.
Adjustments or settings are
suddenly canceled before you
finish.
A certain point on a disc
cannot be played back
properly.
Certain tracks on an MP3 disc
cannot be played back.
A radio station cannot be
received.
A whirring noise is produced.
The timer does not function.
You cannot operate the
System through the remote
control.
Operations are disabled.
24
Meaning
Possible cause
Improper connection.
Headphones are connected.
The MP3 disc is recorded utilizing
"packet writing."
The System was turned off
because of a power cut. The power
cord was disconnected.
Moisture has condensed on the
lens.
There is a time limit.
The disc is scratched or dirty.
These tracks were recorded in a
format other than MP3 format.
No antenna is connected.
The System is located close to TV,
personal computer, or other
electrical appliance.
The System is turned on.
There is an obstruction blocking
the remote sensor on the System.
The remote control batteries are
running low.
The built-in microprocessor may be
malfunction due to external
electrical interference.
Possible solution
Place a disc.
Place a disc with the label side up.
Replace a disc.
Possible solution
Connect all cords properly as in
"Connections."
Disconnect the headphone plug.
The System cannot play back this
type of MP3 disc. Replace the disc.
Set the clock again.
Leave the System turned on for a few
hours, then operate the System.
Repeat the procedure again.
Clean or replace the disc.
The System cannot play back such
tracks. Replace the disc.
Connect an antenna.
Place the System away from TV,
computer, or other electrical
appliance.
After setting the timer, turn off the
System.
Remove the obstruction.
Replace the batteries.
Disconnect the power cord, and then
connect it back in.
Reference
page
5
3
8
2
23
5
2
21
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ux-qx3aUx-qx3wCa-uxqx3wSp-uxqx1wCa-uxqx3aSp-uxqx1a

Table of Contents