Power Trim Fluid; Checking; Filling - Mercury MerCruiser Owner's Manual

Bravo One
Bravo Two
Bravo Three
11. Remove the pump from the oil fill/drain hole. Quickly install the sealing washer and oil
fill/drain screw. Tighten securely.
12. Reinstall the propeller. Refer to Propellers.
13. Recheck the oil level after the first use.
IMPORTANT: Oil level in the gear lube monitor will rise and fall during sterndrive operation;
always check the oil level when the sterndrive is cool and the engine is shut down.

Power Trim Fluid

Checking

IMPORTANT: Check the oil level with the sterndrive unit in the full down/in position only.
1. Place the sterndrive unit in full down/in position.
2. Observe the oil level. Level must be between the "MIN" and "MAX" lines on the
reservoir.
a
3. Fill as necessary with the specified fluid.
Tube Ref No.

Filling

1. Remove the fill cap from the reservoir.
NOTE: Fill cap is vented.
2. Add lubricant to bring level to the within the "MIN" and "MAX" lines on the reservoir.
Tube Ref No.
3. Install the cap.
90-899883295 JUNE 2008
Model Capacity
2736 ml (92‑1/2 oz.)
3209 ml (108‑1/2 oz.)
2972 ml (100‑1/2 oz.)
a - Reservoir
Description
Power Trim and Steering Fluid
114
Description
Power Trim and Steering Fluid
114
Fluid Type
High Performance Gear Lubricant
b
b - "MIN" and "MAX" lines
Where Used
Power trim pump
Where Used
Power trim pump
Section 5 - Maintenance
7876
Part No.
92-858074K01
Part No.
92-858074K01
Page 91