Mercury MerCruiser Owner's Manual page 123

7. Snap the quick‑connect fitting with the water hose into the flush socket on the engine.
8. Open the water source of the water hose to a full flow.
9. Allow the water to flush the sterndrive for 30 seconds.
10. Place the remote control in neutral idle speed position and start engine.
Without sufficient cooling water, the engine, the water pump, and other components will
overheat and suffer damage. Provide a sufficient supply of water to the water inlets during
operation.
11. Operate the engine at idle speed in neutral gear. Do not exceed 1200 RPM.
12. Monitor the engine temperature while operating the engine.
13. Flush the engine for 5 to 10 minutes or until discharge water is clear.
14. Shut off the engine.
15. Allow the water to flush the sterndrive for 10 seconds.
16. Turn off the water source.
90-899883295 JUNE 2008
a - Water hose
b - Quick‑connect fitting (water hose
end)
a
b
c
18489
c - Flush socket
NOTICE
Section 5 - Maintenance
Page 115