Esse INDUCTION EC4i Operating & Installation Instructions Manual

INFORMATION FOR USE WHEN ORDERING SPARES:
Model:__________________________________
Serial Number: ___________________________
Colour: _________________________________
GUARANTEE
Conditions of Guarantee
Your ESSE cooker is guaranteed against defects arising from faulty manufacture for two years, subject to the following express conditions:
A suitably qualified person must install the cooker, and upon installation the details must be recorded on the warranty card and
•
registered with ESSE by returning the correctly completed card. The guarantee period commences upon delivery of the cooker.
The cooker has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions.
•
The cooker has not been serviced, maintained, repaired, taken apart, or tampered with by any person not authorised by us.
•
An approved dealer or representative must undertake all service work under this guarantee.
•
Any cooker or defective part replaced shall become the Company's property.
•
Exclusions
This guarantee does not cover:
Damage or calls resulting from transportation, improper use or neglect.
•
Parts deemed to be replaceable in the normal usage of the cooker; e.g. thermostats, elements, induction hob elements, fans, energy
•
regulators, switches etc.
Control Panel Markings; these can become damaged if a hard abrasive is used.
•
Ceramic Glass Hob; any inherent flaw or defect in the ceramic glass will be immediately evident.
•
Enamel damage; the vitreous coating on your cooker is in effect an extremely thin layer of glass and as such displays all the characteristics
•
of glass. It can easily be damaged by impact, or by spillage of cold liquids onto a hot surface. Such damage cannot be covered under
this guarantee. (See also intermittent use of your cooker, below).
This guarantee is personal to the original purchaser and is non-transferable.
Intermittent Use of Your Cooker
In the event of intermittent use and prolonged shutdown, it should be noted that in some circumstances enamel may be displaced due to
ingress of damp. Whilst this is rare, it is most likely to occur in situations where the unused cooker remains in an unheated property. There is a
layer (known as the groundcoat) between the vitreous enamel surface and the cast iron. Groundcoat is porous and if exposed (e.g. after a chip
in the vitreous enamel coat), may allow damp to penetrate behind the vitreous enamel and spread through the groundcoat. Surface oxidisation
of the cast iron may thereafter occur, causing the vitreous enamel to fall off. Such damage will not be covered by your warranty. We
recommend that a light coating of petroleum jelly be applied to any damaged areas when the cooker is not in use to help keep out the damp.
Customer Care
In the event you should require spare parts, please order through your ESSE dealer. Alternatively from our online spares store.
Should you have cause for dissatisfaction with your cooker, you should contact your ESSE dealer, who will, in most instances, be able to
offer you immediate assistance. You will be required to give the following details:
Your name, address and postcode.
•
Your telephone/contact details.
•
Clear and concise details of the fault.
•
Model and serial number of the cooker (found on the data plate inside the warming cupboard on the back face).
•
Purchase date (please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls).
•
We will then check that we have an accurately completed warranty card, if not then any work carried out may be charged.
Esse Engineering Limited, Long Ing, Barnoldswick, Lancashire BB18 6BN
Tel: 01282 813235 Fax: 01282 816876 e-mail: enquiries@esse.com
Website: http://www.esse.com On-line Store: http://www.esseparts.com
08/11 (PP)
ESSE Electric Cooker
INSTR.CK-EC4i/u
OPERATING & INSTALLATION INSTRUCTIONS OPERATING & INSTALLATION INSTRUCTIONS OPERATING & INSTALLATION INSTRUCTIONS OPERATING & INSTALLATION INSTRUCTIONS
MODEL: INDUCTION EC4i
0