Sony HVR-Z7J Service Manual page 297

3-31. Cam Gear Ass'y, Mode Gear Ass'y
1. Removal procedure
1) Remove the screw (special head screw M1.4 × 1.4) 1.
2) Remove the dowel from the cam base ass'y 2. Slide the cam
base ass'y 2, and remove the pin C, and remove the cam
base ass'y 2.
3) Remove the mode gear ass'y 3.
1 Screw
(M1.4 × 1.4)
2 Cam base ass'y
Dowel
Apply grease
Points to be noted
Apply grease when installing
Amount of grease: A ball of
grease of 0.5 mm diameter.
HVR-Z7J/Z7U/Z7N/Z7E/Z7P/Z7C
Mode gear shaft
Apply grease
Mode gear ass'y
2. Attachment procedure
1) Apply grease equally on the sliding surface of the FP-032 flex-
ible board and the mode gear ass'y.
2) Install the mode gear ass'y 3.
3) Install the cam base ass'y 2 while engaging it in the pin C
and the dowel.
4) Install the screw (special head screw M1.4 × 1.4) 1.
Tightening torque: 0.06 ± 0.01 N•m (0.61 ± 0.1 kgf•cm))
5) Apply grease on the specified locations of the mode gear ass'y.
Amount of grease: A ball of grease of 0.5 mm diameter.
Key Points
in Re-assembling
Alignment mark
Mode gear ass'y
Come gear ass'y
Points to be noted
Apply grease equally when installing.
• After cleaning, grease is applied.
• Be careful so that the dust should not be
adhered to the greased surface.
6-113
3 Mode gear ass'y
Apply grease
Apply grease on the
sliding surface of the
FP-032 flexible board
with the mode gear
ass'y.
FP-032 flexible board