Messages - JVC CA-NXCDR7R Instruction Manual

Messages

Message
ALL SKIP TR Skip marks are recorded to all the tracks.
ALREADY FINAL You are trying to erase a track or add a skip mark on a finalized
disc.
ALREADY UNFIN. You are trying to unfinalize an unfinalized disc.
BLANK DISC Loaded disc is blank.
CANNOT ERASE Loaded disc is damaged. Erasure on this disc is impossible.
CANNOT FIN. Loaded disc is damaged. Finalization on this disc is impossible.
CANNOT LISTEN You are trying to adjust the volume during high-speed recording.
CANNOT REC Disc is damaged. Recording on this disc is impossible.
CANNOT UNFIN. Loaded disc is damaged. Unfinalization on this disc is
impossible.
CDR DISC NG Loaded CD-R is damaged.
DAO DISC You are trying to unfinalize a CD-RW which has been recorded
using the "Disc At Once" recording system.
DISC FULL You are trying to record on a fully recorded CD-R or CD-RW.
NOT AUDIO IN Incoming digital signal is not of an audio format.
NOT REC MUTE You are trying to use the REC MUTE button during Synchro-
nized Recording.
NO AUDIO DISC Loaded disc is not an audio disc.
NO RW DISC You are trying to perform one of the functions which is only
possible on a CD-RW.
NO R/RW DISC You are trying to perform one of the functions which is only
possible on a CD-R or CD-RW.
OPC ERROR OPC cannot be performed. No recording or erasure can be
performed on this disc.
OPC FULL PCA is full. No recording or erasure can be performed on this
disc.
PMA FULL PMA is full. No recording or erasure can be performed on this
disc.
SCMS PROTECT Digital recording is prohibited in accordance with SCMS
regulations.
SHORT REMAIN The remaining time on a disc is shorter than the playing time of
the track you are trying to record.
SKIP FULL 21 skip marks are already recorded.
TNO FULL 99 tracks have been recorded. No further recording is possible.
UNLOCK The external digital component is not connected properly or is
turned off, or its signals are incompatible.
UPDATE OPC OPC is being performed before recording, if a disc is just
inserted in CD Recorder.
Signification
– 55 –
Solution
Replace the disc.
Replace the disc.
Replace the disc.
During high-speed recording, no
sound can be heard; therefore
you cannot adjust the volume.
Replace the disc.
Replace the disc.
Replace the disc.
Replace the disc.
Replace the disc.
Check the source played on the
external component connected to
the LINE DIGITAL IN terminal.
You can only use the REC
MUTE button during Standard
Recording.
Replace the disc.
Load a CD-RW.
Load a CD-R or CD-RW.
Replace the disc.
Replace the disc.
Replace the disc.
See "SCMS" on page 54.
Check the connection, or
playback source.
This is normal. After OPC is
correctly done, recording starts.