Changing The Channel Information; Messages On The Display - JVC MX-KC58 Instructions Manual

To tune in a preset channel
1
Select XM as the source.
Remote Main unit:
control:
2
Select a preset number for the channel you store.
See "How to Select Numbers" on page 9.
• You can also use 4/¢ on the main unit.

Changing the channel information

While listening to the XM Satellite Radio, the currently
selected channel information appears on the display.
You can change the type of channel information.
CH--- P--*
SIGNAL
CATEGORY

Messages on the display

When problems occur, a message appears on the display. In this case, refer to the following solution.
Message
NO SIGNAL
CHECK
XM TUNER
CHECK
ANTENNA
LOADING
OFF AIR
UPDATING
"---"
"CH---"
CH NAME
NAME
TITLE
Possible cause
Signals are too weak.
The XM Mini-Tuner is not properly in-
stalled or the cable is not properly con-
nected.
The XM antenna is disconnected from
the XM Mini-Tuner Dock.
This receiver is loading the channel in-
formation and audio data.
Selected channel is not currently broad-
casting any signal.
The latest encryption code is being up-
dated.
No text information for the selected
channel is available.
Selected channel does not exist or is not
subscribed yet.
CH--- P--* Channel number/Preset number
*Preset number is displayed only for
the channels which are preset.
CH NAME Channel name
NAME Artist name/feature
TITLE Track/program title
CATEGORY Category name
SIGNAL Signal strength
When SIGNAL is selected, current signal strength is
indicated on the display in 4 levels (NO SIGNAL, 1-3).
memo
• Last channel you were listening to will be displayed the
next time you selected XM.
• When you tune in to another channel, the selected channel
number appears on the display.
• When all the text information cannot be shown on the
display at a time, the text scrolls.
• Some characters cannot be displayed correctly.
Solution
Move the XM Mini-Tuner Home Dock near
a south-facing window or where "Channel 1"
can be heard clearly.
Confirm the XM Mini-Tuner is fully seated
in the XM Mini-Tuner Dock.
Then check the connection (see page 17),
and confirm the XM Mini-Tuner Dock cable
is not damaged and fully seated in the XM
terminal jack on the unit front panel.
Confirm the XM antenna is properly con-
nected to the XM Mini-Tuner Dock (see
page 17).
It takes a few minutes to complete. Wait until
loading is finished.
Select another channel.
Wait until updating is finished.
—
—
20