Cobra SPYBALL 6829 User Instructions page 22

Count the flashes. As soon as you reach the number you have chosen as the first
number of your PIN code, turn the ignition off.
Turn the ignition on again and follow the same procedure to select the 3 remaining
numbers.  A short sharp audible signal will confirm that the procedure has been
completed successfully.
Read the code you have entered (see paragraph 16.1.) to make sure it is correct,
then record it.
Note 1): You can select digits between 1 and 18. Once the LED has flashed 18 times, the
procedure stops and needs to be repeated:
Note 2): To quit the procedure without making any changes, turn the ignition off before the
new code is completed.
17. TROUBLESHOOTING GUIDE
Malfunction
The alarm does not respond to
the transmitter.
22
Recommended inspections / operations
Make sure the system has not entered the sleep cycle
-
(see paragraph 15)
Operate the transmitter closer to the unit (the area
-
might be affected by noise interference with the radio
signal)
Replace the transmitter battery
-
Realign the transmitters (see paragraph 2.1. )
-
- If none of these operations is successful, contact a