Reduction Of Audible Alarm Power; Check Control Function - Cobra SPYBALL 6829 User Instructions

8.1. Reduction of audible alarm power

The volume level of the alarm can be reduced when the motorcycle is parked in areas where
noise pollution needs to be minimised. When arming, keep push-button n. 1 of the transmitter
pressed for about 7 seconds. Upon arming, keep push-button n. 1 pressed for about 7
seconds. The reduction of the sound power is confirmed by two deep short audible signals.
This setting is valid for one arming period only.

8.2. Check control function

During the arming time the protection functions of the system can be tested without generating
an alarm cycle.
Arm the system, wait 25 seconds to allow for stabilisation, then test the protection functions as
appropriate during the remaining 40 seconds:
a) If the instantaneous alarm trigger input has been used to protect a case or the storage
compartment under the seat, simulate the removal / opening.  If the simulation is
detected correctly, it is signalled by sharp audible signals.
b) Test the movement sensor, by e.g. simulating an attempt to force the steering lock,
dragging the motorcycle or tilting it up from the side-stand to vertical.  If the simulation
is detected correctly, it is signalled by sharp audible signals. If required, adjust sensitivity.
Turn ignition on.  If the ignition lock tamper protection circuit works properly, you will
c)
hear a sequence of sharp audible signals.
13